Barstow Auto Body Shop | BarstowAutoBody.com

Step #1

Original Vehicle Damage Fusce ut placerat orci nulla pellentesque dignissim enim sit amet. Quam adipiscing vitae proin sagittis. Tempor orci eu lobortis elementum nibh. Non curabitur gravida arcu ac tortor. Ut aliquam purus sit amet luctus venenatis lectus. Arcu cursus vitae congue mauris rhoncus aenean vel elit. Id semper risus in hendrerit gravida rutrum quisque non tellus.Condimentum vitae sapien pellentesque habitant morbi tristique senectus et.

CALL

EMAIL US

Preparation Auto body paint is a delicate process that is best done by the professionals of Barstow Auto Body branch in Fort Irwin. Doing it on your own may not always be safe, as car painting requires a suitable location and equipment. Before painting, Barstow Auto Body thoroughly examines your vehicle for any visible dents and repairs any rust. Ensuring the clean surface of the vehicle before the procedure is vital to achieving a perfectly looking paint job. The most skilled professionals at Barstow Auto Body in Fort Irwin will ensure to remove chrome or plastic trim from the vehicle, as it may interfere with the painting process. Moldings and trim can be replaced right after the service is completed. Our experienced employees who have already perfected the art of auto body painting will deliver the best results and fulfill your vision.

Step #2

Step #3

Sanding The next step in preparing the surface of your vehicle for auto body painting is sanding. This stage is a vital component of the painting process because sanding smoothens the surface, which provides the best conditions for the paint to form a durable and beautiful layer. For the new coat of paint to be applied, the surface must be spotless. Fort Irwin Barstow Auto Body team will sand the vehicle all the way to the bare metal to ensure the best results. Cleaning is another step our professionals take to prepare your ride before painting. Denatured alcohol or mineral spirits are used to remove any oil residue which may interfere with the coating process. Based on your preferred design, Barstow Auto Body in Fort Irwin will then cover certain areas of the vehicle’s surface to create an unforgettable design.

CALL

EMAIL US

Priming To prime the surface of your vehicle, the Fort Irwin team will apply corrosion-resistant and self-etching primer. This substance will prepare the sanded metal for the top coat. Once the primer cures, Barstow Auto Body in Fort Irwin carefully sands the surface before wiping it with the necessary amount of thinner.

Step #4

Step #5

Painting The painting process begins after all the needed preparations have been completed. Barstow Auto Body team in Fort Irwin uses the spray gun to apply three to four layers of paint. With the side-to-side sweeping motion, we ensure that each coat is thin and is applied evenly to create a design that truly stands out. The drying time usually depends on the type of paint used and ranges from 20 minutes to one hour. To avoid any residue, before the last coat is applied, Barstow Auto Body Fort Irwin branch team sands and wipes the surface once again. Using the same technique, the lacquer thinner is then sprayed. After the masking tape is removed, the last step in the process is buffing of the painted surfaces.

CALL

EMAIL US